|
|
MODEL VS-GSWG SWING GATE OPENER
Varible Speed, Linear Drive
Swing Gate Operator
Heavy Duty Industrial Use
|
The OSCO
Model VS-GSWG is a heavy-duty variable speed swing gate
operator designed for smooth, secure and
reliable operation of large, heavy swing gates. The
positive locking linear drive arm design provides enhanced
security, plus increased ability to withstand high wind
loads - especially important for large, heavy gates.
The VS-GSWG features the same proven and reliable UL325/UL991
compliant solid state control circuitry as the rest
of the OSCO family of gate operators and is available
in 1/2, 1 or 2 HP, 115V-460V single- or three-phase
power. The VS-GSWG utilizes an inherent current sensing
system for entrapment protection and is listed for use
in UL class I-IV applications. |
Cabinet: |
Electrical: |
- Weather-resistant
galvannealed steel cabinet with powder coat finish
- Lockable, gasketed,
hinged and removable front cover for easy
|
- Variable speed -
soft start/soft stop programmable through an inverter
motor control (voltage & phase of input power
supply required at time of order)
- Available from 1/2
to 2 hp industrial continuous-duty, three-phase,
56-frame motor
- Available in all
standard voltages and phases
- Run timer for clutch
and motor protection
- Delay on reverse
- Master/Slave capability
built in
- Easily convertible
right hand/left hand
- Solid state control
circuit
- Double C-face brake
- Power on/off switch
- Duplex receptacle
on 115 VAC units
- Three-button control
station included
- Accessory connections
are 24-volt AC or DC
- Easily adjustable
rotary limit switches
- Full system capable
for access controls and reversing devices
|
Mechanical: |
- Heavy-duty 60:1 right-angle
C-face gear reducer
- Adjustable torque
limiter
- Linear drive arm
- Heavy-duty pillow-block
bearings
|
Mounting: |
- 3 - 3 1/2" OD
post mounting
- Optional pad mounting
pedestal available
|
Manual
Release: |
Anti-Entrapment/Detection
Devices: |
- Manual release is
located inside the operator enclosur
|
- Operator is pre-wired
to accept contact and non-contact detection devices
such as contact edges and/or photo electric eyes
|
Warning
Signals: |
|
- Warning beeper to
sound when gate is moving
|
|
|
Ordering
the VS-GSWG Swing Gate Operator:
|
Caution:
Barrier gates are not for pedestrians! Automatic
gate operators are designed for vehicular traffic
only.Tthey are powerful and can cause serious
injury or death. Accordingly, direct all pedestrian
traffic to a separate pedestrian gate. UL325 requires
the use of contact or non-contact anti-entrapment
devices. ASTM F2200 requires that all exposed
rollers are covered. |
|